Set the lease duration time then click Next. The default is 8 days time for leasing one IP address, this time is customization. The lease duration specifies how long a client can use an IP address from this scope.

If there is an IP address that comes in the range of IP address given in DHCP server can be excluded by adding the range of IP addresses. The Length and Subnet mask can be customized also according to requirements. First, enter the Name of the scope the click Next.Įnter the range of IP address that client will have assigned as in the following diagram. Here we define the scope name that will identify the scope. The new scope wizard helps you set up scope for distributing IP addresses to network computers in the network. The DHCP console right click on IPV4 then click on New Scope…to create a new scope. Further information is shared as follows with stepwise actions. When the feature installation succeeded message shown under the progress bar Then click on Close to exit from the wizard.ĭHCP scope has a valid range of IP addresses pool to be given to clients by leasing, the mac address reservation, exclusion and other scope option can be done. Restart the destination server automatically if required, then click Yes and in the last click Install to start the installation process. In next screen you can select multiple roles here we will Click on DHCP Server then a new window appears which show that required tools to be added click on Add Feature.įirst click on the checkbox. Select the server from the server pool on which you are going to install the role as shown in following window then click Next.

Note: Read out the information on the screen that is relevant to the installation of roles and windows sever requirements.įirst Select the installation type as role-based or feature-based installation as shown in the following diagram then click on Next. In the Add roles and features Wizard, click Next. OIn the Server Manager window click Dashboard and then click Add roles and features. To start installation first click the Windows button and then Server Manager. To install the DHCP role in a GUI environment using the following instructions. Write down the command add-WindowsFeature –IncludeManagementTools dhcp This will install the DHCP role with the following output. The other way to open PowerShell is to click Windows button, then Server Manager and from the Server Manager window click the tools and select Windows PowerShell. Click the Windows button, then Windows PowerShell folder and Windows PowerShell as shown in the diagram. It is a command line interface for running command to perform the installation with minimal resources, the same installation which can be done in GUI based environment can be doneįollow the below instructions. DHCP role can be installed using the PowerShell.

Dhcping windows